What we fix
Real problems, real fixes
When we install a tank water heater, we are planning for the next 10 to 12 years, not just swapping one box for another. That starts with a look at the whole setup: incoming water pressure, the size of the unit compared to how your household actually uses hot water, the venting and gas supply or electrical connection, and whether the home needs an expansion tank or pressure regulating valve (PRV). We haul away the old unit, clean up the work area, and show you how to maintain the new heater so it does not fail early.
Tempe is one of the older cities in the Valley, and that shapes a lot of installs. Many homes here date back decades, and the water heater is often in a garage corner, a utility closet, or a tight space that was never designed for easy replacement. Condos and townhomes often put the heater in a small closet with limited clearance. Rental homes and properties near campus bring their own pressure: when the heater fails, a landlord or a household needs hot water back quickly, and the replacement still has to be sized and installed correctly. We assess the space and the demand before recommending anything.
Water quality matters as much as the heater itself. Maricopa County water runs 12 to 18 grains per gallon, and those minerals build up inside the tank, coat heating elements and burners, and use up the anode rod, the sacrificial piece of metal that corrodes so the steel tank does not. High incoming water pressure, often above 80 pounds per square inch (PSI) in the East Valley, shortens heater life faster than almost anything else. A new heater installed without addressing either one is set up to fail early.
We install tank water heaters from trusted, readily serviceable brands, including Bradford White and Rheem. Capacity options typically run from 40 to 75 gallons for residential use, in both gas and electric configurations. If you are upsizing, downsizing, or switching fuel types, we walk through what that means for venting, gas line sizing, and electrical capacity before recommending a path.
Most installs are completed in a single visit, typically 3 to 5 hours on site, and most can be done the same day. If your heater has failed and you are without hot water, tell us when you call so we can prioritize it.
