What we fix
Real problems, real fixes
Replacing a water heater is a long-term decision, and the install matters as much as the unit. Chandler has a lot of homes built between 1990 and 2010, and the water heaters in them are working against two things: hard water and high incoming pressure. Maricopa County water runs 12 to 18 grains per gallon, and that mineral load settles as sediment in the bottom of a tank year after year. Pressure that runs above 80 pounds per square inch (PSI) adds constant stress on the tank, the fittings, and the relief valve. A heater installed without accounting for both will not last as long as it should.
So we look at the whole system before we recommend anything. We check your incoming pressure, inspect the gas or electrical supply, review the venting, and size the tank to match how your household actually uses hot water. Then we install a Bradford White, Rheem, or other high-quality tank water heater with new shutoff valves, new connectors, a properly set temperature and pressure (T&P) relief valve, and an expansion tank when your system calls for one. If your pressure is running high, we will tell you and show you the reading.
Most replacements can be finished in a single visit, and same-day appointments are available. If your tank is leaking, that is an emergency dispatch and we treat it that way. Shut off the cold water supply to the heater, and call us.








